This is my custom design Snakebite stand for CaseStudyno8's Darksaber.
The stand uses the weight of the Darksaber's long grip to hold the emitter guard against the stand's fangs, suspending the saber at a upward angle and showing off as much of the saber from as possible.
The multi-sectioned base allows it to be printed on smaller printer beds and with different colors and types of filament. In the display photos above, I used wood filament, finished with a light Jarrah wood stain to get the rich dark cherry color.
I used two-part Gorilla Glue to assemble this display stand. Remember that this is a resin epoxy that tends to set in a matter of minutes, so don't use very much and make sure to wipe away excess before then.
| base_east_panel.stl | 20.5KB | |
| base_frame.stl | 30.5KB | |
| base_north_panel.stl | 3.7KB | |
| base_south_panel.stl | 8.8KB | |
| base_west_panel.stl | 20.5KB | |
| fang_left.stl | 15.2KB | |
| fang_right.stl | 15.2KB | |
| pin.stl | 7.9KB | |
| stand.stl | 114.9KB |
