Smokestax Segmented Printable Bong 3D Printer Model
The file 'Smokestax Segmented Printable Bong 3D Printer Model' is (blend,stl) file type, size is 4.4MB.
The file 'Smokestax Segmented Printable Bong 3D Printer Model' is (blend,stl) file type, size is 4.4MB.
A three-piece bong that I made for no reason other than to see if I could. The bong is built with a 0.5mm tolerance on all parts, and should be printed solid for best results.
The general thought behind this was to see if I could design a bong that had the drop stem built into it. It needed to be able to be removable in order to be cleaned, but the important parts had to have a great seal, which led to the development of the monstrosity that is the center piece.
Should be printable in around 36-48 hours at 60mm/s, 0.2mm layer height.
This print was designed with smaller form factor printers in mind, and each part will fit on a bed measuring 245x197x120mm.
Comes packed with the blend file for you to edit as you wish!
For further customization, print the center piece out of transparent resin, and watch the smoke travel!
THIS BONG IS NOT DESIGNED FOR USE WITH HEATED BANGERS OR NAILS!!!
NOT FOR DAB USE!
| Smokestax_complete_basic_edition.blend | 9.2MB | |
| Stax_base.stl | 1.5MB | |
| Stax_chimney.stl | 1.8MB | |
| stax_perc.stl | 2.5MB |
