A wallet holder for the Smarttag 2. I keep misplacing my wallet, or more often than not it's moved and I don't know where it was moved to. And running around at 6am looking for it sucks. I use a small low profile wallet with external facing slots, just made sense to make an insert that goes into a cars slot and holds the tag.

There are 2 versions uploaded so far as part of this design. One that has a fully flat base the tag sits on, and one where it cuts though so it is exposed from both sides.

I used TPU as the tag holder and PLA for supports as it just released with a little force.

Pictured is V8 with the full bottom. I will likely be switching to v11 when I get the chance to print it