Smartphone Stand – Super Simple, Easy To Print Phone Holder 3D Printer Model
The file 'Smartphone Stand – Super Simple, Easy To Print Phone Holder 3D Printer Model' is (stl) file type, size is 471.4KB.
The file 'Smartphone Stand – Super Simple, Easy To Print Phone Holder 3D Printer Model' is (stl) file type, size is 471.4KB.
This model answer the need for a very simple design. The holes for the cable are small enought that no support is needed.
Make sure to have good adhesion for the first layer. I printed at 50 mm/s with eryone black 1.75 pla and had no issues.
If you have a beefy cable connector you might encounter clearance issues right below the rectangolar hole. So I made an higher version. Obviously you can print this one if you need an higher stand in general.
The stand is 60 mm wide and rises your phone by 4 cm (5 cm for the higher model).
Leave comments and suggestion.
| CellStandHigher_LorenzoMalizia.stl | 559.3KB | |
| CellStand_LorenzoMalizia.stl | 565.5KB |
