Smartphone Stand #2 (V-shaped) 3D Printer Model
The file 'Smartphone Stand #2 (V-shaped) 3D Printer Model' is (stl) file type, size is 33.2KB.
The file 'Smartphone Stand #2 (V-shaped) 3D Printer Model' is (stl) file type, size is 33.2KB.
This is a very thin folding smartphone stand.
[Remaining problem]
The hinge part may loosen little by little when using it. When the smartphone is in this state, the stand moves to narrow the V-shaped angle and becomes unstable.
[size]
height: 21.5mm, thickness:6mm, length:68mm
[screws to use]
M3 CAP 18mm x1
It is recommended to use glue to prevent the screws from loosening.
No nuts needed.
[print conditions]
-printing type: FDM
-printer: Original Prusa i3 MKS
-filament: PLA
-support: yes
-brim: no
-raft: doesn't matter
-print directions: please refer to the photo
[revisions]
2022/03/28
I change the hinge shape.
I'm sorry, the photos are still the old version.
2022/03/27
I change the print directions and I changed the fine shape.
2022/03/27
The top and bottom chamfers have been made slightly larger to make it easier to open.
2022/03/26
I made the length a little longer. And I narrowed the slot a little.
2022/03/25
I changed the shape of the hinge part a little.
Sorry, this has not been print tested.
2022/03/24
A chamfer was added to the tip to make it easier to open.
| outer-L.stl | 66.7KB | |
| outer-R.stl | 52.2KB |
