THIS IS NOT INVENTED BY ME. THIS IS INVENTED BY MARK MANGER. I HIGHLY RECOMMEND TO VISIT GROPENER WEBSITE: " https://www.gropener.com/ ". THERE YOU CAN BUY THE ORIGINAL BOTTLE OPENER MADE IN ALUMINUM. <<<

GrOpener is the creation of Mark Manger, an Applied Artist from Denver, Colorado. Inspired by the stick & screw openers Mark encountered in Africa in the 1990′s, the GrOpener uses the same leverage principle, but in a form that allows a bottle to be opened through the act of grabbing it. <<<

---

This is super easy to print!

Project video in Finnish (UPDATE: SUBTITLES IN ENGLISH): https://www.youtube.com/watch?v=gM_iu6JYxDA

PRINT WITH SUPPORT MATERIAL (there is a little overhang!)

My first ever 3D creation!

Version 4 (updated 23.6.14):
Now there is 4 different editions:

• Edition one: Basic OHBO
• Edition two: OHBO with a magnet.
• Edition three: OHBO with a coin.
• Edition four: OHBO with a magnet and a coin.
  BTW: The back of the OHBO is for cans! Just stick the tail under the clip of the can to open it!

Magnets from dx.com (here is a link: http://www.dx.com/p/10050078w-round-ndfeb-magnets-silver-50-pcs-239991)

Coin is a 1cent euro coin.

You will also need some super glue if you are printing edition 2,3 or 4.

All editions are right scaled and tested. At the slicing software rotation of the object is only required. I recommend to print with 100% infill (layer height 0.2mm) but my 20% infill opener is also tough enough to open a bottle!

My prints are made of PLA, PLA/PHA and XT plastics! I like to see your prints of this model!
visit: https://www.youmagine.com/designs/smart-one-handed-bottle-opener-by-kart5a