The drawer and slots have just the right amount of tolerance to create a minor air seal if you close the drawers quickly. This was an unintended effect that adds to the sci-fi feel.
For scale, the standard base model in the featured image is about a 90mm cube with some extra depth from the handles on the drawers. Prints well without supports!
| Small_Part_Bin.stl | 12.4KB | |
| Small_Part_Bins_Base.stl | 10.0KB | |
| Small_Part_Bins_Base_2_Wide_Slots.stl | 7.7KB | |
| Small_Part_Bins_Base_4_Small_Slots.stl | 12.4KB | |
| Small_Part_Bins_Base_4_Wide_Slots.stl | 12.4KB | |
| Small_Part_Bins_Base_8_Small_Slots.stl | 21.8KB | |
| Small_Part_Bins_Base_Double_Wide.stl | 17.1KB | |
| Small_Part_Bins_XL.stl | 14.7KB | |
| Small_Part_Bins_XL_Base.stl | 7.7KB | |
| Small_Part_Bins_XL_No_Divider.stl | 11.6KB | |
| Small_Part_Bin_No_Divider.stl | 9.3KB | |
| Small_Part_Bin_Wide.stl | 14.7KB | |
| Small_Part_Bin_Wide_No_Divider.stl | 11.6KB |
