I made this for the GF's fairy garden. Originally to cover a well she made from clay, but it's handy for all sorts of things. It can be stretched along the long axis, scaled, etc.for a variety of uses. The top edges are chamfered at 45 degrees for a clean edge.
There's two styles of roofs and supports, and two lengths of supports.
Roofs: Scalloped and not scalloped. Each with and without grooves on the bottom. The grooves are for placement of the supports - it makes assembly easier. These need supports, but I only use 10%. The grooves are only .7mm deep and fir the supports snugly.
Supports: Plain and fancy. Fancy has curved accents. Woo-hoo. Short and long. Identical, just with an extra inch on the bottom.
Print two of each and you're set. Print at .2 or finer. I used wood colored PLA and dry brushed. Assembled with CA glue.
| post-long-simple.stl | 50.5KB | |
| post-short-simple.stl | 58.3KB | |
| Post_-_Short_fancy.stl | 109.7KB | |
| Roof_-_flat.stl | 7.3KB | |
| Roof_-_Scallops.stl | 111.4KB | |
| Roof_-_Scallops_-_slotted.stl | 118.6KB | |
| Roof_-_Slotted.stl | 14.3KB | |
| Support_-_Long_-_fancy.stl | 97.4KB |
