I was looking for a pegboard holder and found the one I'm remixing here. I saw a comment mention that when slicing, the pegs are printed separately from the main body, and that creates a weak connection.
I recreated this in Cura and then hopped into Tinkercad to re-add the pegs so they would be part of a singular line on the print, and therefore a lot stronger.
This is the same headphone piece with new pegs attached.
One of the uploads has "BOSE" cut out of the front of it, the other is blank.
| SinglePieceHeadphoneHolderPegboard.stl | 102.8KB | |
| SinglePieceHeadphoneHolderPegboardBose.stl | 270.0KB |
