Small Keyboard Fidget 3D Printer Model
The file 'Small Keyboard Fidget 3D Printer Model' is (stl) file type, size is 188.2KB.
The file 'Small Keyboard Fidget 3D Printer Model' is (stl) file type, size is 188.2KB.
I built this fidget toy in blender.
It needed to be taller cause the first time I had made the walls too small.
Materials:
springs
rubber bands
3D printer obviously
filament (I did white)
paper clip to help the rubber bands go through and the supports come off.
and hot glue gun with the glue
It was a little hard at first but I got the hang of it.
Steps:
step 1. printing 1 base and four keys
step 2. grab the materials listed above
step 3. measure and thread the rubber band
step 4. glue the spring down to the peg at the bottom
step 5. put the hot glue on all 4 sides and stick the key in place having the rubber bands touching the hot glue
step 6. wait till it is done drying
step 7. then repeat on all 4 keys
Tips and Tricks: make sure the glue is not touching the walls, all 4 sides at a time rather than a side of 2
| ava_key_fidget_full_base.stl | 35.4KB | |
| ava_key_fidget_full_paw_key.stl | 305.5KB | |
| ava_key_fidget_full_strawberry_key.stl | 190.3KB |
