Small Cube Clock 3D Printer Model
The file 'Small Cube Clock 3D Printer Model' is (stl,brd,ino) file type, size is 51.6KB.
The file 'Small Cube Clock 3D Printer Model' is (stl,brd,ino) file type, size is 51.6KB.
This is a tiny clock built around a small OLED display.
Easy build in just an hour or so!
Things you need to buy:
0.96" Inch I2c IIC Serial 128x64 Oled LCD: http://a.co/1urMxg3
Things from Adafruit:
Breadboard-friendly SPDT Slide Switch - 805
Adafruit Pro Trinket LiIon/LiPoly Backpack Add-On - 2124
Adafruit Pro Trinket - 3V 12MHz - 2010
CR1220 12mm Diameter - 3V Lithium Coin Cell Battery - 380
Adafruit PCF8523 Real Time Clock Assembled Breakout Board - 3295
Lithium Ion Polymer Battery - 3.7v 150mAh - 1317
Total cost like $50
You'll need to mill a small PCB - but wires could work too. It's pretty minimal.
You'll also need to print the enclosure if you want. I chose not to do a face plate but it might look good with one, depends what you like.
I would have gotten the Adafruit OLED but they didn't have them for sale at the time so I went with Amazon. As far as I know the Adafruit one is not going to be compatible with this but I haven't checked.
The code is pretty basic.
The battery lasts 7+ hours and probably could be increased a lot with some tricks to save power.
| Cube.stl | 223.9KB | |
| TinyClock.brd | 29.2KB | |
| TinyClock.ino | 2.0KB |
