1/32nd scale Slot Car scenery.
This is a modular design. Print the parts for 1 bay or 20!
There are specific components for left, right, and middle bays. Printed in PLA. The components are "keyed" to make alignment foolproof. Most pieces will require glue. I used CA/superglue, but I think I'll use hot glue in the future. Resolution and speed are not critical. This isn't an uber realistic design, so even draft quality would probably print nicely. I printed at .15 height, 60mm/s, 10% infill, from PLA, sliced with CURA.
NOTE The second floor has an overhang. Flip it over in your slicer so you don't have to use supports.
This isn't a full depth garage, more of a fascia, at about 4 inches deep. Fits really well into tight track layouts or against a back wall.
Although I envisioned this design, I didn't create the STLs. My friend Peter designed them in his CAD program. We designed the balcony and the roof billboard to accommodate Geezer's printable manufacturer's banners located here: http://slotcarillustrated.com/portal/forums/showthread.php?t=29566
Post print: I ran a file around the edges to square up everything for a nice flush fit.
| balcony_left_hand_end.stl | 1.6KB | |
| balcony_middle_module.stl | 1.4KB | |
| balcony_right_hand.stl | 1.6KB | |
| Frame_left_hand_end.stl | 7.0KB | |
| Frame_middle.stl | 6.5KB | |
| Frame_right_hand_end.stl | 7.0KB | |
| garage_door.stl | 25.5KB | |
| garage_doorway.stl | 3.2KB | |
| ground_floor.stl | 3.0KB | |
| Pit_Lane_Garage.zip | 3.1MB | |
| rooftop_signboard.stl | 3.0KB | |
| roof_left_hand_end.stl | 28.8KB | |
| roof_middle_module.stl | 27.6KB | |
| roof_right_hand_end.stl | 28.8KB | |
| upper_back_wall.stl | 15.6KB | |
| upper_floor.stl | 2.4KB |
