This wallet is based off of "The Ridge" wallet. Make sure that when the piece is in the slicer, you infill from 50-100% for the best results, along with your support density no higher than 10.0%. If your density is higher than that, it will be extremely hard to remove the support under the money clip.
If you find there are any problems with your print, please let me know in the comments.
| slim_wallet_bottom.stl | 35.9KB | |
| slim_wallet_cover.stl | 33.7KB | |
| slim_wallet_money_clip_cover.stl | 55.9KB | |
| slim_wallet_set_.stl | 161.3KB | |
| slim_wallet_top.stl | 36.1KB |
