Sliding Closet Door Floor Guide 3D Printer Model
The file 'Sliding Closet Door Floor Guide 3D Printer Model' is (stl) file type, size is 135.0KB.
The file 'Sliding Closet Door Floor Guide 3D Printer Model' is (stl) file type, size is 135.0KB.
This is a sliding door guide for closet doors where one door closes on the left and the other on the right. Without this guide, the doors will swing freely perpendicular to the intended sliding direction. I modeled them after this set at Lowe's, but made them a bit bigger overall for stability and durability. I also rounded all edges to make sure you don't hurt your foot on them.
The overall design is 120mm long by 30mm wide by 31mm tall, including a 4mm thick base. The door gap for each section is 36mm, which is just enough for a standard door to slide between easily. The holes on either side have a 4.5mm diameter, which easily fits a #8 stainless screw. I used the #8 x 1-1/2 in. screw to hold this in place on each end (see this kit at Home Depot).
| Sliding_Closet_Door_Floor_Guide.stl | 367.7KB |
