This Action Master style Skyfire is in response to a request by IsaacmusPrime for a Jetfire toy. This toy is larger than the standard Action Master in size.
I would suggest printing the head on its back with supports, the arms on their side with the post parts sticking up with supports, printing the backpack standing up on its jets with supports (not how I did on its back, it came out a bit ugly), the upper legs with the smaller hole side down and supports, the back jets on their sides with supports, pretty much everything should have supports. The body and back should snap together when finished (this was due to wanting to have the jetpack post go into the entire body). The leg accessories should be printed with the slot hole down. Superglue the leg accessories onto the legs. You will need two small screws to attach the upper legs to the waist (the kind that's used in a PC will work). I only printed two guns because I needed two objects that were the same height to get the barrels to come out correctly, so it's optional if you'd rather print something else as tall (like a sacrificial block).
| Skyfire_Arms.FCStd | 5.3MB | |
| Skyfire_Back_Wing_1.stl | 34.1KB | |
| Skyfire_Back_Wing_2.stl | 34.1KB | |
| Skyfire_Body.FCStd | 7.0MB | |
| Skyfire_Body_Back.stl | 47.0KB | |
| Skyfire_Body_Chest_repaired.stl | 82.5KB | |
| Skyfire_Head.FCStd | 325.3KB | |
| Skyfire_Head.stl | 111.3KB | |
| Skyfire_Jetpack.stl | 130.4KB | |
| Skyfire_Left_Arm_repaired.stl | 1.4MB | |
| Skyfire_Left_Leg_Accessory.stl | 20.3KB | |
| Skyfire_Lower_Left_Leg.stl | 43.2KB | |
| Skyfire_Lower_Legs.FCStd | 420.6KB | |
| Skyfire_Lower_Right_Leg.stl | 43.2KB | |
| Skyfire_Right_Arm_repaired.stl | 1.4MB | |
| Skyfire_Right_Leg_Accessory.stl | 17.8KB | |
| Skyfire_Upper_Legs.FCStd | 59.7KB | |
| Skyfire_Upper_Leg_Left.stl | 38.3KB | |
| Skyfire_Upper_Leg_Right.stl | 52.1KB | |
| Skyfire_Waist.FCStd | 288.0KB | |
| Skyfire_Waist.stl | 145.2KB | |
| Skyfire_Weapon.FCStd | 210.9KB | |
| Skyfire_Weapon.stl | 98.1KB |
