Box for the srk 1.3 board, with 2 Lerdge (4mm crew holes at 62 * 38 mm) style mosfets. Got some holes for connections, cable zip tie arcs, and a 120mm fan on top. PSU part is not done yet, and the sd card might be hard to reach, since i only use it to flash, let me know if anyone need some changes.
I designed it so it is attachable to any plane surface with 3 holder. In my case it will be the bottom side of a Ikea lack table, outside of the enclosure, to maintain proper temperature.
Should be printable with any material, just take the heath produced by the mosfets into consideration.
Holder is with 0.4 tolerance, very tight!
Holder_0.8 is 0.8 mm tolerance, it makes easier to remove the box.
| box.stl | 925.9KB | |
| holder.stl | 38.8KB | |
| holder_0.8.stl | 38.8KB | |
| top.stl | 157.1KB |
