This is not my design. This was a free kit inside TinkerCAD. I just thought I'd share it for those that don't use TinkerCAD. See picture of TinkerCAD screen showing where to find it.
This model stands 7.25 inches tall. After cleaning up the joints and lubricating them, this thing is extremely posable. You can put it in almost any position, and it holds very nicely.
Thanks TinkerCAD!!
SKELETON-Whole(orig) is the original model, with some difficult points.
SKELETON-Whole(mod) is the modified version that prints better.
Update: As mentioned and reposted by arboriginal, I've added a break-out of each piece so they can be edited/scaled/printed one at a time. Thanks for the idea.
Update: Found original designer, BitsnBolts, here on Thingiverse. You can find this and other cool designs on his page.
Update 12/13/23 : By request I've uploaded "Assembled-noPrint" as a whole skeleton so you can test different SCALE sizes to get the height/size you want. Then apply that scaling to the printable version. Good luck! (for instance, 160% scale produces a skeleton about 29cm tall)
Update 6/7/24: Issues with pelvis (vertical ball joint breaks easy - reports of failed prints). So, I created a Horizontal Pelvis. This prints much more successfully, and with no vertical ball joints, it is much stronger. I'd use a little bit of supports for this one.
| Assembled-noPrint.stl | 4.7MB | |
| Foot.stl | 285.3KB | |
| Fore-Arm.stl | 312.5KB | |
| Hand.stl | 295.0KB | |
| Head.stl | 328.1KB | |
| Pelvis-Horizontal.stl | 435.6KB | |
| Pelvis.stl | 285.8KB | |
| Shin.stl | 303.7KB | |
| Shinw-raft.stl | 314.7KB | |
| SKELETON-Wholemod.stl | 4.9MB | |
| SKELETON-Wholeorig.stl | 4.7MB | |
| Thigh.stl | 281.0KB | |
| Torso.stl | 635.3KB | |
| Upper-Arm.stl | 298.8KB |
