Skeleton HDD Rack 3D Printer Model
The file 'Skeleton HDD Rack 3D Printer Model' is (stl) file type, size is 188.6KB.
The file 'Skeleton HDD Rack 3D Printer Model' is (stl) file type, size is 188.6KB.
Minimal modular skeleton for stacking UNLIMITED* number of hard drives on top of each other. Alternate with double and single brackets on opposite corners to lock drives with each other or use CenterLock if possible. Use adapters to change drive size from 3.5 to 2.5. (Two ways: 2.5CenterAdapter or 2.5BackAdapter.) Mount under a desk with upside down brackets. Small size makes printing fast and cheap!
*UNLIMITED may be restricted by gravity or force majeure.
Disclaimer: Any hard or software failures are at users own will to comply, i am not to be held as a captive or a reason of any mishaps that may or may not occur while applying this concept of mounting of any drives, disks or loopholes.
| 2.5BackAdapter.stl | 63.8KB | |
| 2.5BackAdapterDouble.stl | 117.8KB | |
| 2.5Centeradapter.stl | 53.3KB | |
| 2.5Double.stl | 87.9KB | |
| 2.5FrontAdapter.stl | 82.4KB | |
| 2.5FrontAdapterLoose.stl | 54.9KB | |
| 2.5Single.stl | 37.6KB | |
| 3.5Double.stl | 62.4KB | |
| 3.5Single.stl | 26.1KB | |
| 3.5to2.5Back.stl | 57.2KB | |
| 3.5to2.5Front.stl | 58.0KB | |
| 3.5to2.5FrontDouble.stl | 69.5KB | |
| CenterLock.stl | 57.7KB | |
| FloorMount.stl | 19.2KB | |
| UpSideDownMount.stl | 19.2KB | |
| UpSideDownMountLock2.5.stl | 34.6KB | |
| UpSideDownMountLock3.5.stl | 45.3KB |
