Utensil holder for doing dishes. There's an incline on the inside so that water doesn't sit at the bottom. Water should flow forward and fall into the sink; although if you test it with a faucet like I did, you might get some flow out of the sides since the side pattern is cut low (but this isn't the typical use case lolz)
Material: PETG
Infill: 15%
Layer Height: .25mm; I set the bottom layers to 6 to make it more dense at the bottom, but probably doesn't make much of a difference.
Supports: No
| utensil_holder2_v1.stl | 102.9KB |
![Topfdeckel-Halterung Geklebt / Pot Lid Holder Glued [27 – 30cm] 3D Printer Model](https://cdn.3axis.co/assets/c4/39/a9/19/c439a919-d202-4be1-9e1a-4c7ec7b56ef6/images/5a072098-bf22-420a-a843-827da411e802_thumb.jpg)
