I wanted to change my CTC to a single extruder printer. With the lightweight head I hope to get even better prints or to print at higher speed.
A great design is thing http://www.thingiverse.com/thing:1336355
But I missed the cable guide. "You move the problem of braking cables just a few mm to the top", friends said, but I just feel better with the guide. So I found the remix http://www.thingiverse.com/thing:1345768
With this thing the right side of the top, where the filament is led through, had a gap between itself and the extruder. I thought it would be better to lay it down. So I shortened the middle part and changed the top in a way, that the original screws still fit.
You have to print
CoolerNozzle
CoolerBody2
of the original thing: http://www.thingiverse.com/thing:1336355 too.
| coolertop-kurz.FCStd | 442.2KB | |
| CoolerTop_Cable_Protection_erhoeht.FCStd | 395.5KB | |
| CoolerTop_Cable_Protection_erhoeht.stl | 69.5KB | |
| CoolerTop_kurz.stl | 35.0KB |
