Completely redesigned the original gauge pod I created as it could not fit 3 gauges. New version guaranteed to fit 3x 62mm gauges (AEM X-Series) and others from my knowledge. The model now protrudes slightly out of the shifter bezel to allow for all three gauges to fit. It barely clears my radio above and still allows for me to access all buttons.This version is a 30 degree bank instead of the sharp 45 degree I originally used as it could interfere with some shifters.
The model is secured using the provided nuts and still has great clearance to run the cables. I use exact measurements, such as 180mm din size and 52mm gauge pod clearance so fit will vary based on your printer calibration.It was difficult to install the shifter bezel over the gauges, so some sanding may be necessary.
STEP files provided for modifications! Please let me know if any changes should be made, and I will update the files if necessary.
(Printer had an issue and resulted in my bad and ultimately shortened print, but still fit in my car and works as a prototype)
| S13_Gauge_Pod.step | 120.2KB | |
| S13_Gauge_Pod.stl | 1.3MB |
