Inspired by SnakeJayd design using servo motor and Arduino Uno which I already have. In order to simplify the design and reduce in printing time and material, I have base the design on using an existing egg tray from supermarket quail eggs casing.
Warning: When the Egg turner first start up it would move very fast to default position. The speed is so fast it can damage your eggs or throw it out. So before power up or when resetting please remove the the whole egg tray.
The programming is from SnakeJayd I have fine tune it to my needs. It set to repeat every 3 seconds for test. Please Follow to comment to set to 2 hour for each rotation.
Part needed:
1x SG90 Micro Servo Motor
1x Arduino board
2x Nails 1.5mm wide
1x Zip tight (Tight on nail as stopper)
1x Quail eggs case
Update:
10/05/2019: Added new base lower by 18mm name Low, original design rename as High.
13/04/2019: Arduino code updated: fix Arduino Uno integer limit cause delayTime not working over 32 seconds.
| Simplify_Quail_Eggs_Turner_-Whole.stl | 47.6KB | |
| Simplify_Quail_Eggs_Turner_-_Base_High.stl | 23.7KB | |
| Simplify_Quail_Eggs_Turner_-_Base_Low.stl | 23.5KB | |
| Simplify_Quail_Eggs_Turner_-_Tray_Holder.stl | 25.0KB | |
| Simplify_Quail_Eggs_Turner_Code.ino | 1023.0B |
