A remix of my old design, same print settings and assembly steps apply (yes you still need the 21 mm motor). Additionally to to the redesigned lighter stand it also features the motor cover and a channel for wires.
Any material should be fine, but i reccomend materails that can withstand some heat like PETG or ASA and ABS in case your motor gets hot.
Wire and motor cover simply slide on existing parts as shown in the picture.
| holder.step | 20.2KB | |
| holder.stl | 113.4KB | |
| housing.step | 103.8KB | |
| housing.stl | 2.7MB | |
| motor_cover.step | 44.0KB | |
| motor_cover.stl | 1.2MB | |
| propeller.stl | 518.1KB | |
| stand_1.step | 66.4KB | |
| stand_1.stl | 138.8KB | |
| stand_2.step | 65.6KB | |
| stand_2.stl | 138.8KB | |
| wire_cover.step | 22.7KB | |
| wire_cover.stl | 30.2KB |
