Nice, easy print for a single 18350, 18650 or 21700 Lipo-cell holder with screw-on cap. Simple design, feels good in hand and screws on tight. SIngle cell version only.
Roughly 1hr 30 min print for largest part (base).
I have included the sketchup file so you can start there if you need another size.
Enjoy!
PLEASE NOTE*** Double check your 21700 file (slice it) to make sure there is a compete tube for the battery. Early version had bug when slicing that didn't cut the hole all the way down. Apologies! Updated file should be good to go! (12-20-23)
Enjoy!
| 18350_18650_21700_holders_g22.skp | 2.4MB | |
| 18350_holder_BASE_g22.stl | 276.3KB | |
| 18350_holder_CAP_g22.stl | 272.3KB | |
| 18650_holder_BASE_g22.stl | 279.9KB | |
| 18650_holder_CAP_g22.stl | 272.3KB | |
| 21700_holder_BASE_g22.stl | 277.3KB | |
| 21700_holder_CAP_g22.stl | 273.7KB |
