This is a simple 3D printed RC boat, optimized for 0.4mm nozzles.
The entire build can be done in only 3 hours (including print time)!
The boat uses very simple and common electronics:
To make the boat water tight, several layers of ABS slurry were applyed on the inside and outside (http://www.instructables.com/id/100-Warp-Free-MakerBot-3D-Printing/step1/Put-ABS-Scraps-and-Acetone-in-a-Jar/)
I hope you enjoy this little project, and be sure to check out my profile for more RC stuff!
| Boat.stl | 7.2MB | |
| boat_propeller.stl | 412.2KB | |
| Boat_Rudder.stl | 316.5KB |
