Simple Filament Spool Stand For Samla 3D Printer Model
The file 'Simple Filament Spool Stand For Samla 3D Printer Model' is (stl) file type, size is 25.3KB.
The file 'Simple Filament Spool Stand For Samla 3D Printer Model' is (stl) file type, size is 25.3KB.
Remixed Simple Filament Spool Stand V2 for Samla storage box.
You can fit 4 x 1KG filament spools inside a Samla storage box.
It uses the same standard 608 bearings as the original Simple Filament spool stand.
Because the long spacer is too long for my printer, so I split it in two. An one piece version is also included.
The Spool Stand was hot-glued to the bottom to prevent it from moving around, so it is OK to split the spacer in two.
Tubes can be added to the Spool Stand for thinner filament spool. But remember, you cannot add the tube after assembly.
This spool stand can be used with my Upper Tray for Samla Filament Box.
** An updated version is available here: Stronger Filament Spool Stand for Samla.
| Filament_Spool_Stand_001.stl | 28.6KB | |
| Filament_Spool_Stand_002.stl | 4.3KB | |
| Filament_Spool_Stand_003.stl | 9.3KB | |
| Filament_Spool_Stand_004.stl | 12.2KB | |
| Filament_Spool_Stand_Tube.stl | 62.0KB |
