I wanted to make a gift box for my bridesmaids for the bracelets I got them, since the boxes they came in were not to my liking. I had filament in my wedding colors, so I whipped this design up and they look great!
There is just enough clearance for these to be a bit loose, but I did that because not all printers are the same. If it's too loose, I found that adding clear tape to the inside of the lid around the sides, where you can't really tell, works great!
I printed this on regular PLA, but the test print was on HS PLA and turned out great too.
| Base_Bracelet_Box.3mf | 61.4KB | |
| Base_Bracelet_Box.stl | 30.7KB | |
| Bracelet_Box_v2.step | 21.7KB | |
| Lid_Bracelet_Box.3mf | 134.3KB | |
| Lid_Bracelet_Box.stl | 156.9KB | |
| top_box_v1.step | 38.8KB |
