[2024.12.08] UPDATE
Eventually the PETG rotor also melted, so I printed this with a resin printer. Anycubic Tough resin 2.0 black.
It was needed to adjust the hole diameter a bit, because the resin printer is more accurate. Also a spacer is introduced, then the rotor blades does not touch the plastic under the rotor in case if the rotor "sinks".
Updated files added with a suffix v2.
[initial text]
The rotor in my Silvercrest popcorn maker melted. I remade the rotor.
I would print this from PETG or ABS, or maybe even better to use higher temp resistant material.
| lapát-PartPolarPattern.stl | 102.2KB | |
| lapát.FCStd | 357.7KB | |
| rotor_v2.FCStd | 388.3KB | |
| rotor_v2.stl | 133.2KB |
