The file 'Silicone Rubber Mold For Slimterface 3D Printer Model' is (SLDPRT,STL) file type, size is 513.3KB.
Silicone resin mold for a silicone rubber gasket on the slimterface
Instructions
=> print and use either 00 10 or a combination of 00 10 and 00 05 + mica power or dye
=>spray a very light coating of silicone release spray on the mold
=>peel extremely gently & slowly
Afterwards you can paint some of your 00 10 silicone on the slimterface and let the gasket cure over the course of a couple hours
I don't reccommend superglue for sealing the rubber to the slimterface, as it has cure inhibition on silicone resins... Basically any silicone sealant will do the job better than superglue if you want to use anything else
Commercial release will never happen on this as its inherently fragile
| dumb_gasket_SI_ideathickk.SLDPRT | 449.2KB | |
| dumb_gasket_SI_ideathickk.STL | 190.9KB |
