Siege Tower Readme.txt

This model has been designed for 28mm tabletop miniature wargaming.

It has been designed to be printed on an SLA printer and has not been tested on FDM style printers.

Test model was printed on an Elegoo Mars. All wall and floor pieces printed well when the wood grain on the planks were orientated vertically without supports.

This model contains the following pieces to make it complete:

FLOORS
Siege Tower Bottom Floor with Axles
Siege Tower Second Floor
Siege Tower Third Floor
Siege Tower Parapet Floor

WALLS
Siege Tower LH Side Wall
Siege Tower RH Side Wall
Siege Tower Front Shield Wall
Siege Tower Parapet LH Side
Siege Tower Parapet RH Side
Siege Tower Parapet Front Side

NON STRUCTURAL PARTS
Siege Tower Wheel (x6)
Siege Tower Axle Rail (x2)
Scaling_Ladder-16_Rung
Siege Tower Boarding Ramp <- Install pivot shaft before final gluing side walls

The following parts are optional to accommodate restricted printer build volume or magnetizing the boarding ramp.

Replacing Siege Tower LH Side Wall:
Siege Tower LH Side Wall Spit Lower Half
Siege Tower LH Side Wall Spit Upper Half

Replacing Siege Tower RH Side Wall:
Siege Tower RH Side Wall Spit Lower Half
Siege Tower RH Side Wall Spit Upper Half

These optional parts are modified to hold a 1/4 x 1/16 inch N52 Neodymium magnet to hold the ramp in the up position:
Siege Tower Parapet Front Side with Quarter Magnet Hole
Siege Tower Boarding Ramp with Quarter Magnet Hole