http://www.sp-dynamo.com/8Xseriesdynamo%20hub.html
http://www.sp-dynamo.com/8-series-pic/connect-installation.pdf instructions for connector installation.
I have an Exposure (rebrand of Shutter Precision) PD-8X 6V, 3W dynamo hub, for which I got exactly one contact housing & connector.
Took the best measurements I could with calipers; they're very small pieces & therefore hard to measure.
I didn't take any special measures for 3D printing; just exactly what I read off of the pieces. Highest resolution/layer height would be recommended.
I am particularly concerned about whether or not the snap fit will work.
Untested. Let me know if you do test it.
Update: see the last picture. Pictured on the bottom is a Shimano dynamo hub connector. The top row are the respective SP connector components. As far as I can tell, without taking measurements they should both work the same. The SP one is a bit wider (so the interface to an actual SP hub would be nicer), but the actual connection should be the same. Shimano may be speccing slightly smaller wires.
| Contact_housing.SLDPRT | 162.8KB | |
| Contact_housing.STL | 45.8KB | |
| Cover.SLDPRT | 157.0KB | |
| Cover.STL | 14.3KB |
