Shopsmith In/Out Feed Table Adaptors 3D Printer Model
The file 'Shopsmith In/Out Feed Table Adaptors 3D Printer Model' is (stl) file type, size is 8.7KB.
The file 'Shopsmith In/Out Feed Table Adaptors 3D Printer Model' is (stl) file type, size is 8.7KB.
Shopsmith Mark V, 510
Allows the use of the floating extension tables as in feed or out feed tables using the 510 Table, Tubes, Extension Tables, and a stand.
For Outfeed:
Print both files. I recommend printing at 50% gyroid infill.
For Infeed:
Print the Left File, then print the Left File mirrored. Again, recommend printing at 50% gyroid.
If you rotate the STL 90deg so the thin edge is down, you will not need supports. If you print as is, I recommend using supports due to the ledge on each file.
At 50% gyroid infill, this should take about 100g of filament.
| ShopsmithFeedTableLeftSideV3.stl | 24.7KB | |
| ShopsmithFeedTableRightSideV1.stl | 24.7KB |
