I found a few similar designs on Thingiverse. I didn't like the placement of the clamp screw on some of the designs and found that on other designs the shifter was not in the correct place on the handle bar.
This design is used with my Shimano Deore XT SL-M8000 right hand shifter.
The following hardware preferably stainless is required.
1x M5 x 11mm
1x M6 x 18mm
1x M6 Nut
You will need to tap the M5 hole with 0.8mm thread to secure the shifter to the clamp. I am looking to use this temporarily until I can source and replace with an aluminum version but am quite happy with how it turned out.
Included is a right hand and left hand version, the print does not require any support when printed.
Enjoy!
| Shimano_i-spec_ii_bar_clamp_L.stl | 3.0MB | |
| Shimano_i-spec_ii_bar_clamp_R.stl | 3.1MB |
