PROPERTY OF SNK. USED WITHOUT PERMISSION.

this was one of the first models i printed. the print was OK but i updated the STL/BLEND to make it easier on your printer. included STL is at 2xSS since i was exceeding the file size limit at 3xSS but the BLEND is set to 3xSS so you can export STL from there... you'll have to split her body in half anyway.

the skirt and panties had to go since the 2 objects clipping through her body were too much booleans for resoloving a proper inner and outer wall. removed the 'shirt laces' since they'll just break on you when removing supports like mine did (but you can still unhide them in the BLEND if you're feeling brave).

i tried using 'silicone caulking' to fill her separated shoulder (under-supported) which was a bad idea -- always use wood filler. her ponytail snapped off 3 times (but glued back without any problems). i snapped her finger off too when removing supports and glued it back kind of crooked... like i said this was one of my first prints and it came out fine all things considered.

i re-used some chains from her outfit to tie it all together. fur trim will need a lot of supports.

i hope you enjoy this modelrip as much as i do.