Shark Vertex Rocket Adapter 3D Printer Model
The file 'Shark Vertex Rocket Adapter 3D Printer Model' is (stl) file type, size is 715.3KB.
The file 'Shark Vertex Rocket Adapter 3D Printer Model' is (stl) file type, size is 715.3KB.
This is an adapter to fit Shark Rocket parts to the cordless Shark Vertex cordless vacuum. This is meant to be printed in three parts. Print both adapter portions on their flat side, a few supports should be needed for mild overhangs. Once printed, use rough sandpaper (220ish) to scuff up the flat part of each print. Glue together with super glue.
For the button, I printed it on its side so the circular pins print accurately. Make sure you have good overhang support. You will need a spring with OD ~7mm. Absolute max is 8mm. My spring was about 10mm uncompressed and ~3.5mm compressed. Place the spring in the button housing circle and place the button over top. You should have enough room to press fit in the button pins.
| shark_rocket_male.stl | 157.1KB | |
| shark_vertex_button.stl | 334.9KB | |
| shark_vertex_male.stl | 3.3MB |
