This is a wall mount system for the Shark FlexStyle hair tool. You should print each part separately and then assemble them as directed below.
This was originally only the frame that was intended to be used with Snuffle88's wall mount system for the Shark FlexStyle hair dryer. It seems Snuffle88 has removed their account, and the Shark holders along with it. I have reuploaded them as part of this thing. If I need to take them down, I will. I created the frame so that you don't have to make 6 holes in the wall. It will also make moving the whole system a lot easier.
The frame will print on a 220 mm x 220 mm print bed, but nothing smaller.
The top 2 screw holes are for mounting the frame to the wall. The other screw holes can either be used for mounting or for securing the parts into the frame. Screw size is M3.
The 2 brushes go in the bottom slot, and the 3 curlers go at the top. The FlexStyle holder goes on the left. You can either glue Snuffle88's pieces into the frame, screw them in with a M3 screw and nut, or both. 8mm long screws should work.
| CE3V3KE_Shark_FlexStyle_2_accessories_mount.stl | 278.1KB | |
| CE3V3KE_Shark_Flexstyle_extension_cord_hook.stl | 163.4KB | |
| CE3V3KE_Shark_Flexstyle_mount.stl | 63.4KB | |
| Shark_Flexstyle_Acc_Holder_3.stl | 127.5KB | |
| Shark_Flexstyle_Holder_Frame.stl | 172.5KB |
