Similar to THR ( Tudor Hart Racing) and hudy. Setup Wheels and angles gauge for setting up your 1/10 buggy / car. You need some printed paper and some glass ( I had glass tiles from from an IKEA item).
Tried printing laid down ( faster print) but there was quality issues. This is why the upright, on a raft, works the best for this model.
Because it is a 13h print, you could print them in parts.
Interestingly the Front and Rear axes are different in size (see photos), so you need to mark the front and rears. Same HEX size used.
| angles_gauge_1_2_3.stl | 1.6MB | |
| setupwheel_FRONT.stl | 30.4KB | |
| setupwheel_REAR.stl | 47.5KB |
