A simple pump using a cheap 9g servo. Some post printing and decent tolerance needed.
Use V2 if the original doesn't fit on (although it will always be a tight fit, some servos have a larger pin)
Be sure to waterproof the servo!
Flip the servopump and impeller files over before printing
This design only has about a foot of head pressure, I will test other impeller designs to see if I can increase the pressure, although it will mean sacrificing flow.
| impeller.STL | 54.9KB | |
| inlet.STL | 17.8KB | |
| servopump.STL | 85.9KB | |
| servopumpV2.STL | 78.5KB |
