==== New design here : https://www.thingiverse.com/thing:5373065 ====
For some months now, I've been running pure DIY temperature + humidity sensors at home. They all are based on the same electronic design (Wemos D1 Mini, Wemos Battery Shield, additional resistor for voltage sensing and DHT22), and run a fully homemade firmware.
Currently they all are hosted in poor recycled cardboard boxes; a pain in the... eyes.
Thus I needed a custom casing that could house all these parts.
This is my first design with Fusion 360, hope that will be ok...
Sensor Casing has enough room for a Wemos D1 Mini (4x 2mm hole for screws), a 18650 Li-Ion battery holder and a simple sensor, such as DHT22 or SHT30.
Height is around 3 cm in order to host a wemos-based 2 elements stack, such as D1 mini + battery shield.
Print it, use it, enjoy it, and pls send your comments!
Update 2021/01/16 - Added Smaller box
| Indoor_Probe_Base_v14_High.stl | 289.3KB | |
| Indoor_Probe_Cover_v14_High.stl | 48.5KB | |
| SensorBoxSmaller_-_Base.stl | 293.6KB | |
| SensorBoxSmaller_-_Cover.stl | 48.9KB |
