Still not sure whether it works or not? Check this YouTube video then: https://youtube.com/shorts/54BiBE97o5k
A self balancing bird toy I designed as an experiment, which turned out to work perfectly after a few iterations.
It was sculpted using zbrush and refined using Blender.
If you have troubles printing it, check out my YouTube video about it!
https://youtu.be/MDfjgsP0VXQ
It works even when it's 1cm/ 0,39in in width:
https://youtube.com/shorts/w8_KZAmZRkU
PRINT SETTINGS - These were mine, but are not the rule. Feel free to change them depending on your needs :)
Layer height: 0.16mm
Print speed: 60mm/s
Wall speed: 30mm/s
Infill: 20%
Supports: Everywhere, overhang angle 53º
Build plate adhesion: Brim
Let me know in the comments if you have printed it!
| BalancingBird.stl | 22.1MB |
