I used the SD/microSD holder customizable by hackermagnet card holder for a while. Unfortunately, I didn't have the correct parts to assemble it correctly.
Finally, I have redrawn this project in Fusion 360 to fit the parts I have lying around.
I have used M2 screws with M2 brass inserts, 8mm and 2mm diameter magnets.
The rest of the project is basically the same as the hackermagnet's project.
I hope you will find it useful.
Bottom.stl | 199.1KB | |
Magnet_plug.stl | 35.9KB | |
Middle_x2.stl | 106.7KB | |
Middle_x4_x1.stl | 150.3KB | |
Middle_x8.stl | 193.8KB | |
Screw_Plug.stl | 35.2KB | |
Small_Magnet_Plug.stl | 34.0KB | |
Spacer.stl | 39.3KB | |
Top.stl | 201.4KB |