This ultimately is the product of laziness. I had seen a lot of holder type accessories on here for SD Card and MicroSD card reader extensions... The problem was that I had already wired mine up, and I would have to remove a lot of stuff to be able to run the cable through the back of the holder and reconnect it afterwards. So I made this one that is open at the top, so I wouldn't have to disconnect anything to install it. Hopefully it helps someone as lazy as me.
This is made for the full size SD extension.
Also, this was the first thing I have made with Fusion 360, still learing. There is a slight artifact at the bottom back corners of the model, but they are so small the slicer completely ignored them even at 0.1mm.
| sdcardholder.stl | 119.6KB |
