This is a slim one piece replacement for the factory pump grip for the SCSA Taipan.

It uses the non standard hardware of:

6x m5x12 countersunk screw

This is to reduce the profile as much as possible.

When printing please print 1 Main body and two Grip Adapters, attach the grip adapters to the action bar and then slide on the main body so that all the holes line up, there are cut outs in the main body for a positive connection.

Print at high wall count and infill.
PLA not recommended due to temperature warping, most other filaments such as ABS, PETG, PACF ect should work well.

Print the Main body standing on its end, and the Grip Adapters flat, neither should need supports with a tuned printer.