This is a slim one piece replacement for the factory pump grip for the SCSA Taipan that includes and ergonomic angled foregrip.

It uses the non standard hardware of:

4x m5x12 countersunk screw for the sides

2x Factory grip bolts for the bottom/grip to attach

This is to reduce the profile as much as possible.

When printing please print 1 Main body and two Grip Adapters, attach the grip adapters to the action bar and then slide on the main body so that all the holes line up, there are cut outs in the main body for a positive connection.

Print at high wall count and moderate infill.

PLA not recommended due to temperature warping, most other filaments such as ABS, PETG, PACF ect should work well.

Print the Main body standing on its end or on the back of the angles grip, and the Grip Adapters flat, Supports and brim will be needed on the main body.