Scribedriver Pencil Case 3D Printer Model
The file 'Scribedriver Pencil Case 3D Printer Model' is (3mf,stl) file type, size is 517.0KB.
The file 'Scribedriver Pencil Case 3D Printer Model' is (3mf,stl) file type, size is 517.0KB.
Here's a pencil case that very specifically holds the LTT Scribedriver and a Faber-Castell TK 4600. Included is an additional insert that holds pencil leads for the TK 4600. The case slides open and closed in quite a satisfying way.
Case openings are 8mm in diameter and may fit other writing implements but it's not intended too.
Assembly:
Lid snap fits onto the inner part of the case
Insert the inner part with the outer case
Press fit the tab into the small opening of the inner case, this can be difficult so I end up pushing mine against the table.
| Pencil_Case_-_SamIam.3mf | 291.4KB | |
| Pencil_Case_inner.stl | 193.4KB | |
| Pencil_Case_inner_-_space_for_lead.stl | 189.1KB | |
| Pencil_Case_lid.stl | 166.7KB | |
| Pencil_Case_outer.stl | 105.1KB | |
| Pencil_Case_Tab.stl | 37.0KB |
