These are containers for parts, jewelry, pills, etc, that I developed from my prior forstner bit cases.
Print them open side up and do not use support.
Any lid will fit any bottom.
The bumps on the top edge of the bottom container are there to keep you from screwing it so tight you can not get it open as the lid will screw all the way down.
| Fluted_Bottom_1.stl | 14.3MB | |
| Fluted_Bottom_2.stl | 14.6MB | |
| Fluted_Bottom_3.stl | 14.9MB | |
| Fluted_Bottom_4.stl | 15.1MB | |
| Fluted_lid.stl | 7.6MB | |
| Spiral_Bottom.stl | 28.2MB | |
| Spiral_Bottom_2.stl | 31.2MB | |
| Spiral_lid.stl | 5.7MB | |
| Spiral_Lid_2.stl | 6.0MB |
