These are screw mounting plates for all the Shelf Brackets I have remixed and posted.
https://tinyurl.com/yyw6rc6h
While the mounting tape I recommend is super strong, some may wish to use screws and anchors to mount the brackets. These plates use 3 flat head screws to securely mount to a wall and then you can use the mounting tape or your preferred glue to mount the actual bracket to the plate.
My bracket designs come in 3 configurations so use the appropriate mounting plate.
Small width bracket (approx 28mm wide): MOUNTING-PLATE-SMALL.stl or WITH-LIP
Large width bracket (either single file or left/right files): MOUNTING-PLATE-LARGE.stl or WITH-LIP
THERE ARE TWO VERSIONS OF EACH PLATE - WITH AND WITHOUT A BOTTOM LIP.
JUST REMEMBER - IF YOU RESIZE THE BRACKETS IN YOUR SLICING SOFTWARE - YOU MUST ALSO RESIZE THE MOUNTING PLATE BY THE SAME PERCENTAGE.
Since these will be load bearing - Print with at least 30% infill. The more the better.
DISCLAIMER: Although I have tested the brackets and mounting tape for my own use, I am not responsible for any damage or injuries that may result from your use.
| MOUNTING-PLATE-LARGE-WITH-LIP.stl | 6.2MB | |
| MOUNTING-PLATE-LARGE.stl | 3.2MB | |
| MOUNTING-PLATE-SMALL-WITH-LIP.stl | 3.4MB | |
| MOUNTING-PLATE-SMALL.stl | 3.2MB |
