Just what everyone needs, an overly complicated phone stand! This is a completely hardware free design that allows you to adjust the angle of your phone or tablet by turning the adjustment screw.
Update
-I have added a tray with a cutout for a charger but I have not had a chance to print it yet. I suspect it may be slightly more difficult than the original.
Print Tips:
Print the screw laying on it's side with supports.
Print the base without supports.
Print the link on it's side so that layers go through the pins.
Print the tray on it's side with supports for the pin mounts.
If the knob is loose, glue it.
The capture frame should be a tight press fit.
Assembly:
| ScrewAdjustPhoneStand-base-STEP.step |
| ScrewAdjustPhoneStand-capture-STEP.step |
| ScrewAdjustPhoneStand-knob-STEP.step |
| ScrewAdjustPhoneStand-link-STEP.step |
| ScrewAdjustPhoneStand-nut-STEP.step |
| ScrewAdjustPhoneStand-screw-STEP.step |
| ScrewAdjustPhoneStand-traycutout-STEP.step |
| ScrewAdjustPhoneStand_base.stl |
| ScrewAdjustPhoneStand_capture.stl |
| ScrewAdjustPhoneStand_knob.stl |
| ScrewAdjustPhoneStand_link.stl |
| ScrewAdjustPhoneStand_nut.stl |
| ScrewAdjustPhoneStand_screw.stl |
| ScrewAdjustPhoneStand_tray.stl |
| ScrewAdjustPhoneStand_tray_w_charger_cutout.stl |
