Science Olympiad: RobotGeek Snapper Arduino Robot Arm Extensions 3D Printer Model
The file 'Science Olympiad: RobotGeek Snapper Arduino Robot Arm Extensions 3D Printer Model' is (dxf,stl) file type, size is 135.0KB.
The file 'Science Olympiad: RobotGeek Snapper Arduino Robot Arm Extensions 3D Printer Model' is (dxf,stl) file type, size is 135.0KB.
Extensions for the RobotGeek Snapper Arm for the Science Olympiad robot arm competition. Meets all the requirements listed here.
You can 3d print this with the STL or laser cut it with the DXF. For center supports, I used 20mm standoffs and 3mm spacers. Accommodates M3 Bolts for the supports and M2 bolts at the ends.
You can find the necessary standoffs in the Standoff Variety Pack, and the necessary bolts in the Metric Nut and Bolt Variety Pack.
WARNING: Extending the Snapper Robot Arm puts incredible stress on the servos, as it was designed to be used at the length it was made. Notice that using this WILL ABSOLUTELY shorten the lifespan of your servos. Burnt out servos are not covered under any warranty. Use with caution at your own risk.
| Snapper_Extension_1.dxf | 3.7KB | |
| Snapper_Extension_1.stl | 59.7KB | |
| Snapper_Extension_2.dxf | 4.0KB | |
| Snapper_Extension_2.stl | 77.6KB | |
| Snapper_Extension_3.dxf | 4.4KB | |
| Snapper_Extension_3.stl | 95.0KB | |
| Snapper_Extension_4.dxf | 4.9KB | |
| Snapper_Extension_4.stl | 111.6KB | |
| Snapper_Extension_5.dxf | 5.2KB | |
| Snapper_Extension_5.stl | 126.8KB | |
| Snapper_Extension_6.dxf | 5.6KB | |
| Snapper_Extension_6.stl | 142.5KB | |
| Snapper_Wrist_Extension.dxf | 5.5KB | |
| Snapper_Wrist_Extension.stl | 129.4KB |
