Needed something to store two vehicules in one Kallax/Expedit shelve.
Hardware required :
12x12x1 (mm) metal tubing cut to fit (235mm was ok for the XV01 and V100 but a bit narrow for the BBX and Scorpion)
4 m3 screw
Print one master (with control-box) and 3 "slave" posts.
Print 4 inserts
Print 2 half ramp
No real need for glue. Ramps may appear flimsy at their connexion but the car's weight is far enough.
Simply cut the metal square tube to length, slide in the inserts at both ends, slide the beam in it's posts and set height with screw.
Assemble ramps and slide them on the beams. Adjust their spacing to taste.
22-10-2023 :
posts-v2 : thicker base plate
inserts-v2 : should slide easier in the posts
14-11-2024 :
posts-v3 : enlarged base plate for more stability
| Garage_Lift_4_posts_-_inserts-v2.stl | 65.7KB | |
| Garage_Lift_4_posts_-_inserts.stl | 65.7KB | |
| Garage_Lift_4_posts_-_posts-v2.stl | 570.4KB | |
| Garage_Lift_4_posts_-_posts-v3.stl | 569.7KB | |
| Garage_Lift_4_posts_-_posts.stl | 568.2KB | |
| Garage_Lift_4_posts_-_ramp.stl | 7.3KB |
